JVC Autocal using ColourSpace Remote Control

Omardris
That is great news!!!

Steve

Thanks for this Ted and Omardis. Be very interested to see how it goes, I'll let you know how I go.

Stuart

Hi,
I would like to point out that the interface between JVC-AutoCal and the remote control from ColourSpace also works with the current version of JVC-AutoCal 13 v1.20.
The user only has to copy the alternative files into the program directory of JVC-AutoCal 13 v1.20 according to the instructions (Quickstart.pdf).
Peter

New Version of the JVC-Autocal Adjustment for ColourSpace
I have revised the remote connection from JVC-Autocal to ColourSpace.
The goal of this interface is to enable the use of all sensors supported by the respective version of ColourSpace with JVC-Autocal.
The selection of sensors depends on the ColourSpace license.
The settings, correction methods, etc., provided in ColourSpace for each sensor are applied.
There are two new versions of the customisation:
"CS_4_autocal_v3" for JVC-Autocal 14v1.2 and earlier, i.e., the older JVC projectors and models NZ500 through NZ900.
Quick Guide for CS_4_autocal_v3:
https://magentacloud.de/s/Bmgttr5wYt4L4ZG
"CS_4_autocal_v5" for JVC-Autocal 14v2.0 and later, meaning it is only for the current JVC projectors NZ500 through NZ900.
Quick Start Guide for CS_4_autocal_v5:
https://magentacloud.de/s/W3PwksB9m9tBFPj
All ColourSpace license levels, including ZRO (32-bit & 64-bit), are supported.
Both versions of CS_4_autocal require a license file, which costs 10 euros.
Without a license, you can establish a connection to ColourSpace for testing purposes, but you cannot take any measurements.
Please read the quick start guide for more information.

Distribution of the older ColourSpace calibration via displaycalibrations.com (TED) has ended. Thank you very much for your support.

Feel free to contact me via PM or email (videoarte@t-online.de) for further details.