Hello
I have a Raspberry Pi 3 Type B+ as PGenerator.
This is displayed in Lightspace with IP in the Network Manager.
Connected to the JVC with HDMI there are no test images.
The input displayed is 1080p/60.
What do I do wrong. Maybe someone can help me?
Thanks

Hi,

If you select to run a Quick Profile of Gray Only, do you have patches displayed to your projector?

Better to use 1080p24 patch generation as some display/projectors can provide different results with 24p vs 60p input signal. As the movie content is 24p, no need to use 60p patch generation.

It's been explained there: https://displaycalibrations.com/lg_2018_oled_profiling_using_lightspace.html

Hello

No test images are displayed.
But I think it should also work with 1080/60.
I will try to set the PGenerator to 24hz.
Can I do that with Putty?

Now I tried it with Putty and the command "hdmi_mode=32".
But the setting remains at 1080/60.
How can I change the screen resolution?

You will use Device Control Interface to change PGenerator settings.

Which Device Control Interface do you mean.
The one from the JVC projector or the Raspberry.
Thank you

You can download/install DeviceControl Interface and see some instructions there: https://displaycalibrations.com/lg_templates_for_device_control.html

Then from a web-browser, you create a new device with your PGenerator, use translation of this page: https://www.avmagazine.it/forum/88-calibrazione-proiettori-e-display/301272-rpg-rpi-p attern-generator-by-biasi

Then you can change the PGenerator device settings from your browser.

Thanks for the support.
I will try it out.

I installed the device tool.
Could also switch to 1080/24.
Still don't have any test images.

Contact me here: https://displaycalibrations.com/contact_us.html