After making many mistakes and spending enormous numbers of hours trying to calibrate my FSI BM211 with :
"ColorSpace for FSI LTE" , an M1 MacbookPro , a ColorChecker Display Pro , and having sent my probe to FSI for custom bpd files,
I felt I finally did this right - but the resulting LUT is terrible - clearly too Red..

I let my BM211 warm up for about a half hour before running the software, used the slow Cube based profiling , and when completed the software said my LUT would be 97% accurate ( I don't remember the exact wording .)

However When looking at SMPTE color bars the Blue bar is very desaturated.
Looking at a 10 step grey chart , there is clearly a red tint to some of the steps.
Likewise ordinary video looks too red in the shadows.
My trusty old default 709 setup still looks fine though .

So now what ? Am I doing something wrong or is this as accurate this system will get ?
I'm enormously disappointed.

BTW - This same probe was able to pretty accurately calibrate my Mac screens 8 months ago using the included software.

Leonard Levy

I would say you must be doing something wrong.
But it is impossible to tell what without far more information.
As you purchased ColourSpace LTE FSI your first point of contact for support should be FSI.
They will be able to look at your profile and generated LUT and assist you in understanding what has been done incorrectly.

If you want to post the same profile and LUT here we can also have a look.

Steve

Leonard - as you have not followed-up here, I guess you have spoken to FSI and they have been of assistance?

Steve

No actually I haven't spoken to them. I got very busy and decided I should try again before calling them .
I will do that in the next couple of days . Then repost my results.