When doing a calibration on an Eizo CG3145 yesterday, I made use of the new Red, Green and Blue Gain controls.
They all did exactly what they were supposed to, but when disconnected and reconnected, as you would when changing slots, ColourSpace ended up reading the incorrect Blue Gain value.
For the display in question, the Interactive Controls settings were:
Brightness: 439
R Gain: 451
G Gain: 456
B Gain: 512
These settings, plus the LUT, loaded perfectly.
However when the slot was re-read by ColourSpace, the B Gain came back as "456" , (the G Gain value).
Changing the G Gain value and repeating the re-read would change the B Gain to the same.
If you changed anything, this wrong B Gain value would then be loaded to the Eizo.
You can of course manually change the value to 512 and all is good again.
The ColourSpace version was v1.0.1.224 and the Eizo was a CG3145 with SDK: 3.36.1 | 